PLANET WAP-7500 - Manual (Page 21)

Figure 11 Vent
2.2.4 Connect Up
Before installing the Ethernet cable with a waterproof RJ-45 connector, it is recommended that the
Cat-5 RJ-45 coaxial cable be used for the WAP-7500 to power PoE connector.
1. To connect to the hole labeled PoE+Data, open the black cover in advance by using a coin or a
slotted screwdriver and then screw in the body of the gland and tighten.
Figure 12 Connect Up – Step 1
2. Slide the sealing nut to the RJ-45 cable from its middle breach and then insert the sealing into
the cable.
Slide the Sealing Nut from its Breach
Figure 13 Connect Up – Step 2
3. Insert the RJ-45 connector and make sure that the locking tab snaps home.
Page 21