PLANET WNAP-7300 - Manual (Page 53)

5.4 Restore Factory Default Settings
The WNAP-7300 provides two ways to restore the factory default settings:
Restore factory default settings via Web
From “Configuration File”, clicking “Reset Settings to Default” will eliminate all current settings
and reboot your device, then default settings are applied.
Figure 37 Restore Settings
Restore factory default settings via Reset Button
If software in the WNAP-7300 is unexpectedly crashed and no longer reset the unit via Web, you
may do hardware reset via the reset button. Press and hold the button for at least 5 seconds and
then release it until the PWR LED gives a blink.
5.5 Reboot
You can reboot your WNAP-7300 from “Configuration File” in “Management” as below:
Click “Reboot” and hit “Yes” upon the appeared prompt to start reboot process. This takes a few
minutes.