PLANET WNAP-7300 - Manual (Page 30)

LAN Settings: When DHCP Server is disabled, users can specify IP address and subnet mask
for the WNAP-7300 manually. Make sure the specified IP address is unique on your network in
order to prevent IP conflict. When DHCP Server is enabled, users may specify DHCP IP Address
Range, DHCP Subnet Mask, DHCP Gateway and Lease Time (15-44640 minutes).
Warning:
In AP mode, the WNAP-7300 must establish connection with another wireless device
before it is set to Router mode. In Router mode, it is impossible for users to access
device via wired port, for WAN is on wired port and LAN is on wireless port. Users can
access device through the wireless device connected with the WNAP-7300.
In wireless client mode, users can access the WNAP-7300 via its wired port, for WAN
is on wireless port and LAN is on wired port when device is set to Router mode.
Bridge mode and AP+Bridge mode are similar to AP mode when device is set to
Router mode; WAN is on wired port and LAN is on wireless port. Thus users must also
connect the WNAP-7300 with another wireless device before it is set to Router mode
and access the WNAP-7300 via the connected wireless device.
3.5 Time Settings
Compliant with NTP, the WNAP-7300 is capable of keeping its time in complete accord with the
Internet time. Make configuration in “Time Settings” from “System”. To use this feature, check
“Enable NTP Client Update” in advance.