PLANET WNAP-7300 - Manual (Page 28)

provides path redundancy while preventing loops in a network. STP allows only one active path
at a time between the access points but establish the redundant link as a backup if the initial link
fails.
STP Forward Delay: STP Forward Delay is the time spent in detecting and learning network tree
topology state before entering the forward state. Default time value is 1 sec.
TCP/IP Settings
Open “TCP/IP Settings” in “System” as below to configure the parameters for LAN which
connects to the LAN port of the WNAP-7300. In this page, users may change the settings for IP
Address, Subnet Mask, and DHCP Server.
Figure 17 TCP/IP Settings (Bridge)
Obtain IP Address Automatically: If a DHCP server exists in your network, you can check this
option, thus the WNAP-7300 is able to obtain IP settings automatically from that DHCP server.