PLANET WNAP-7300 - Manual (Page 23)

- 13 -
Chapter 3 Basic Settings
3.1 Factory Default Settings
We’ll elaborate the WNAP-7300 factory default settings. You can re-acquire these parameters by
default. If necessary, please refer to the “ Restore Factory Default Settings ”.
Table 1 Factory Default Settings
Features Factory Default Settings
Username admin
Password admin
Wireless Device Name apXXXXXX (X represents the last 6
digits of Ethernet MAC address)
Operating Mode AP
Data Rate Auto
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Gateway 0.0.0.0
Primary DNS Server 0.0.0.0
LAN
Secondary DNS Server 0.0.0.0
Spanning Tree Enable
802.11 Mode 802.11a/n
Country/Region United States
Channel Number 149
SSID Wireless
Broadcast SSID Enable
HT Protect Disable
Data Rate Auto
Output Power 100% (Full)
Channel Mode 20MHz
WMM Enabled
RTS Threshold (byte) 2346
Fragmentation Length (byte) 2346
Beacon Interval 100
DTIM Interval 1
Space in Meter 0
Flow Control by AP Disable
Security Open System
Encryption None