PLANET ICA-HM620 - Manual (Page 18)

2.4 Dome Camera Setups
Before connecting the IP Camera to other devices of IP Surveillance system, please complete the IP
Camera’s ID and communication switch settings. These switches are located on the bottom of the IP Camera.
2.4.1 Switch/Connector Definition
Item Description
A RJ-45 Connector
B
ALARM I/O
C
Power
D Micro SD Card Slot
E
Factory Reset Button
F
Audio I/O
Note
DO NOT change the Speed Dome IP Camera’s Communication Switch factory default
settings.
2.4.2 Communication Switch Setting
Communication Switch SW Description Default
SW 1 DSS (Digital slow shutter) ON
SW 2 Reserved OFF
SW 3
Reserved OFF
SW 4 Reserved OFF
SW 5 Default PTZ setting, not include IP card OFF
SW 6
Disable pan/tile OFF
Please do not change the default setting without qualified specialist or supplier’s notice.
2.5 Power & Audio Connector Definition
Please refer to the illustrations below to connect power core through the supplied power adaptor, and set up
the audio according to the Audio pin definition.
- 18 -