PLANET WGSD-10020 - Manual (Page 208)

User’s Manual of WGSD-10020 Series
Host : Sender IP filter is set to Host. Specify the sender IP address in the SIP
Address field that appears.
Network : Sender IP filter is set to Network. Specify the sender IP address and
sender IP mask in the SIP Address and SIP Mask fields that appear.

Sender IP Address When "Host" or "Network" is selected for the sender IP filter, you can enter a
specific sender IP address in dotted decimal notation.

Sender IP Mask When "Network" is selected for the sender IP filter, you can enter a specific
sender IP mask in dotted decimal notation.
 Target IP Filter Specify the target IP filter for this specific ACE.
Any : No target IP filter is specified. (Target IP filter is "don't-care".)
Host : Target IP filter is set to Host. Specify the target IP address in the Target IP
Address field that appears.
Network : Target IP filter is set to Network. Specify the target IP address and
target IP mask in the Target IP Address and Target IP Mask fields that appear.
 Target IP Address When "Host" or "Network" is selected for the target IP filter, you can enter a
specific target IP address in dotted decimal notation.
 Target IP Mask When "Network" is selected for the target IP filter, you can enter a specific target
IP mask in dotted decimal notation.
 ARP SMAC Match Specify whether frames can hit the action according to their sender hardware
address field (SHA) settings.
0 : ARP frames where SHA is not equal to the SMAC address.
1 : ARP frames where SHA is equal to the SMAC address.
Any : Any value is allowed ("don't-care").
 RARP SMAC Match Specify whether frames can hit the action according to their target hardware
address field (THA) settings.
0 : RARP frames where THA is not equal to the SMAC address.
1 : RARP frames where THA is equal to the SMAC address.
Any : Any value is allowed ("don't-care").
 IP/Ethernet Length Specify whether frames can hit the action according to their ARP/RARP
hardware address length (HLN) and protocol address length (PLN) settings.
0 : ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the (PLN) is
equal to IPv4 (0x04).
1 : ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the (PLN) is
equal to IPv4 (0x04).
Any : Any value is allowed ("don't-care").
 IP Specify whether frames can hit the action according to their ARP/RARP
hardware address space (HRD) settings.
0 : ARP/RARP frames where the HLD is equal to Ethernet (1).
1 : ARP/RARP frames where the HLD is equal to Ethernet (1).
208