Avago Technologies MegaRAID SAS 8204ELP - Manual (Page 8)

viii Preface
Copyright © 2007 by LSI Corporation. All rights reserved.
connector with locking tabs. If you are disconnecting this type of
cable, press in on the locking tabs before you disconnect the cable.
As you pull connectors apart, keep them evenly aligned to avoid
bending any connector pins. Also, before you connect a cable, make
sure that both connectors are correctly oriented and aligned.
•
Handle components and cards with care. Do not touch the
components or contacts on a card. Hold a card by its edges or by its
metal mounting bracket. Hold a component, such as a
microprocessor chip, by its edges, not by its pins.
Protecting Against Electrostatic Discharge – Static electricity can
harm delicate components inside your computer. To prevent static
damage, discharge static electricity from your body before you touch any
of your computer’s electronic components, such as the microprocessor.
To discharge static electricity, touch an unpainted metal surface, such as
the metal around the card-slot openings at the back of the computer.
As you continue to work inside the computer, periodically touch an
unpainted metal surface to remove any static charge your body may have
accumulated. In addition to the preceding precautions, you can also take
the following steps to prevent damage from electrostatic discharge:
•
When unpacking a static-sensitive component from its shipping
carton, do not remove the component from the antistatic packing
material until you are ready to install the component in your
computer. Just before unwrapping the antistatic packaging, be sure
to discharge static electricity from your body.
•
When transporting a sensitive component, first place it in an
antistatic container or packaging.
•
Handle all sensitive components in a static-safe area. If possible, use
antistatic floor pads and workbench pads.