Avago Technologies MegaRAID SAS 8204ELP - Manual (Page 40)

2-8 MegaRAID SAS Hardware Installation
Copyright © 2007 by LSI Corporation. All rights reserved.
Figure 2.4 shows SAS and SATA II connectors on SAS and SATA II
physical disks, respectively. Cables connect internal connectors on the
RAID controllers to connectors on SAS drives, SATA II drives, or both.
Both SAS and/or SATA II physical disks can connect to SAS backplane
receptable connectors. The difference between the SAS connector and
SATA II connector is the bridge between the SAS primary physical link
and power connector on the SAS controller, which the SATA II connector
does not have.
Note: SAS backplane connectors can accept SAS or SATA II
physical disks, but SATA II backplane connectors cannot
accept SAS drives.
Figure 2.4 SAS and SATA II Plugs and SAS Backplane Receptacle
Connector
The following subsections provide step-by-step instructions for
connecting the SAS RAID controllers to SAS physical disks and SATA II
physical disks, either directly or through an expander.
Figure 2.5 through
Figure 2.6 show the MegaRAID SAS 8408E RAID controller and the
MegaRAID SAS 8480E RAID controller connected to physical disks and
to expanders, which then connect to physical disks.
Serial ATA
SAS Primary
Physical Link
SAS Secondary
Physical Link
Power
SATA II
Physical Link
Power
Serial Attached SCSI
SAS Backplane
Receptacle Connector
Note: SATA II backplane connectors
do not accept SAS drives.
Power
SAS Secondary
Physical Link
SATA II/SAS
Primary
Physical Link