Avago Technologies MegaRAID SAS 8204ELP - Manual (Page 6)

vi Preface
Copyright © 2007 by LSI Corporation. All rights reserved.
Revision History
Safety Instructions
Use the following safety guidelines to help protect your computer system
from potential damage and to ensure your own personal safety.
Note: Use the MegaRAID 1078-based SAS RAID controllers
with UL-listed Information Technology Equipment (ITE)
products only.
When Using Your Computer System – As you use your computer
system, observe the following safety guidelines:
Caution: Do not operate your computer system with any covers
(such as computer covers, bezels, filler brackets, and
front-panel inserts) removed.
•
To avoid damaging your computer, make sure that the voltage
selection switch on the power supply is set to match the alternating
current (AC) power available at your location:
– 115 volts (V)/60 hertz (Hz) in most of North American and South
American countries, and some Far Eastern countries, such as
Japan, South Korea, and Taiwan.
– 230 V/50 Hz in most of Europe, the Middle East, and the Far East.
Also make sure that your monitor and attached peripherals are
electrically rated to operate with the AC power available in your
location.
•
To avoid possible damage to the system board, wait 5 seconds after
you turn off the system before you remove a component from the
system board or disconnect a peripheral device from the computer.
Document Number Date/Version Remarks
80-00157-01 Rev. B September 2007 Added the SAS 8708EM2 RAID controller, and the SAS
8880EM2 RAID controller
80-00157-01 Rev. A February 2007 Initial release of the document.