Avago Technologies 3ware 9650SE-12ML (Channel) - Manual (Page 14)

Working with the Background Task Mode
10 9.5.2 Addendum to the 3ware SAS/SATA RAID Software User Guide
Setting the Background Task Mode
You set the Background Task Mode on the 3DM 2 Controller Settings page.
Settings are available for both Rebuild/Migrate and for Verify. By default,
both Background Mode settings are set to
Adaptive .
(You can also change these settings using the CLI. For details, see 3ware SAS/
SATA RAID Controller CLI Guide, Version 9.5.2.)
To change the Background Task Mode
1. Choose Management > Controller Settings from the menu bar in 3DM 2.
2 In the Background Task section of the Controller Settings page, select the
Background Mode you want for Rebuild/Migrate and for Verify.
Figure 7. Background Task Mode on the 3DM 2 Settings page
The page refreshes and a message appears at the top to confirm the
changes you make.
Related CLI commands
You can also view, set, and change Background Task Mode and Task Rate
settings using the CLI. For details, see 3ware SAS/SATA RAID Controller CLI
Guide, Version 9.5.2 In particular, see information about the following CLI
commands:
• /cx show rebuildrate
• /cx set rebuildrate
• /cx show rebuildmode
• /cx set rebuildmode
• /cx show verifyrate
• /cx set verifyrate
• /cx show verifymode
• /cx set verifymode