Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 17)

LSI Corporation | January 2011 Page 17
MegaRAID SAS Device Driver Installation User Guide Chapter 6: SCO OpenServer 6 and SCO UnixWare 7 Driver Installation | Installing the Driver in a New SCO
OpenServer 6 or SCO UnixWare 7 System
Chapter 6
This chapter describes the installation of the SCO OpenServer 6 driver and the SCO
UnixWare 7 driver and consists of the following sections:
 Section 6.1, Installing the Driver in a New SCO OpenServer 6 or SCO UnixWare 7 System
 Section 6.2, Upgrading the Driver on an Existing OpenServer 6 or UnixWare 7 System
6.1 Installing the Driver in a
New SCO OpenServer 6 or SCO
UnixWare 7 System
When you install the SCO OpenServer 6 operating system or the SCO UnixWare 7
operating system, insert the megasas Driver Supplement media before you insert any
HBA drivers supplied with your media kit.
Use the following steps on a SCO OpenServer 6 system or a SCO UnixWare 7 system to
create an HBA driver diskette from the HBA diskette image file.
1. Go to the root directory, and create a new directory by typing the following
command:
$ su
Password: <type your root password>
# mkdir /tmp/hba
# cd /tmp/hba
2. Download the megasas_sco.image file to the newly created /tmp/hba directory
on your system.
3. Make a megasas HBA diskette from the image file by typing the following
command:
# dd if=megasas_sco.image of=/dev/dsk/f0t obs=36b
4. Use the megasas HBA diskette during system installation.
Use the following steps on a SCO OpenServer 6 system or a SCO UnixWare 7 system to
create an HBA CD from the HBA ISO image file.
1. Go to the root directory and create a new directory by typing the following
command:
$ su
Password: <type your root password>
# mkdir /tmp/hba
# cd /tmp/hba
2. Download the megasas_sco.iso file to the newly created /tmp/hba directory on
your machine.
SCO OpenServer 6 and SCO UnixWare 7 Driver Installation