Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 11)

LSI Corporation | January 2011 Page 11
MegaRAID SAS Device Driver Installation User Guide Chapter 3: Novell NetWare Driver Installation | Novell NetWare Driver Files
Chapter 3
This chapter provides installation instructions for the MegaRAID Novell NetWare driver
and consists of the following sections:
 Section 3.1, Novell NetWare Driver Files
 Section 3.2, Installing the NetWare Driver in a New NetWare System
 Section 3.3, Installing or Updating the NetWare Driver in an Existing NetWare System
3.1 Novell NetWare Driver
Files
The MegaRAID Novell NetWare driver and utilities support logical drives configured on
the MegaRAID controller. This driver supports up to 12 MegaRAID controllers.
NOTE: The logical drives configured on the host adapter are registered with the
operating system as separate logical units.
Table 2 describes the MegaRAID Novell NetWare driver files.
All utilities and ASPI drivers expect the MegaRAID driver to pass the requests to the
adapter.
Novell NetWare Driver Installation
Table 2: MegaRAID Novell NetWare Driver Files
File Description
mega_sas.ham The MegaRAID host adapter module (HAM). This driver supports
the NPA Diagnostics option by using the NWDIAG flag, which is
specified on the command line when the driver loads.
The driver is a re-entrant module. It registers one adapter when
you issue the Novell NetWare
LOAD command to load the driver.
mega_sas.ddi The device driver installation file. It is needed to install the
MegaRAID HAM driver.