Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 15)

LSI Corporation | January 2011 Page 15
MegaRAID SAS Device Driver Installation User Guide Chapter 5: SUSE Linux Enterprise Server (SLES) 9.0, 10.0, 11.0 Driver Installation | Installing the Driver in a New
SuSE SLES Linux System
Chapter 5
This chapter describes how to install the SUSE Linux Enterprise Server (SLES) 9.0, 10.0,
and 11.0 driver in the RAID-configured drives and consists of the following sections:
 Section 5.1, Installing the Driver in a New SuSE SLES Linux System
 Section 5.2, Updating the SuSE SLES 9.0, 10.0, or 11.0 Driver
5.1 Installing the Driver in a
New SuSE SLES Linux System
NOTE: If you use Service Pack (SP) 1 or SP 2, you need to load the driver.
If you use SP 3 RC 2, the MegaSAS driver is already on the SuSE SLES Linux CD.
You can install the MegaRAID device driver in a new SuSE SLES Linux 10.0 or 11.0
system from the SuSE SLES Linux CD. In addition, you can install the MegaRAID device
driver in a new SuSE SLES Linux 9.0, 10.0, or 11.0 system from a floppy diskette.
5.1.1 Installing from CD To install the driver in a new SuSE SLES Linux 10.0 or 11.0 system from the SLES Linux
installation CD, perform the following steps:
1. Boot the server with the SLES SP CD-ROM Disk 1.
The system BIOS must support booting from a CD-ROM. BIOS settings might require
changes to allow CD-ROM booting. See your system documentation.
2. At the installation message, press ENTER.
The driver is installed from the CD.
SUSE Linux Enterprise Server (SLES) 9.0, 10.0, 11.0 Driver
Installation