Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 10)

Page 10 LSI Corporation | January 2011
MegaRAID SAS Device Driver Installation User Guide Chapter 2: Windows Driver Installation | Installing or Updating the MegaRAID Driver in an Existing Windows System
3. Select “S” to specify an additional device when the screen displays:
"Setup could not determine the type of one or more
mass storage devices..."
The system prompts for the manufacturer-supplied hardware support disk.
NOTE: If the screen does not display this message after you press F6, then the setup
program did not recognize the F6 command. Reboot the system, and return to
step 2 .
4. Insert the driver diskette containing the Windows device driver and press ENTER.
5. Select the appropriate MegaRAID adapter from the menu by using the arrow key to
highlight it, and then press ENTER to proceed.
6. Press ENTER again to proceed.
7. Return to the Windows Setup screen.
8. Windows displays a “Welcome to Setup” window.
9. Press ENTER to continue.
10. Press C to continue the Microsoft Windows installation procedure.
11. Follow the Windows installation procedure.
12. Repeat this process for all the adapters on your system.
2.2 Installing or Updating the
MegaRAID Driver in an Existing
Windows System
Perform the following steps to install or update the MegaRAID device driver in an
existing Windows system:
1. Boot the Windows operating system.
The Found New Hardware Wizard starts.
2. Click the Next button and insert the driver diskette into the A:\ drive.
3. Click the Search for a Suitable Driver... button, and click Next.
4. Click the Next button.
In some cases, a message displays saying that this driver is not digitally signed. This
message informs you that a nonsigned driver is being installed. If this message
displays, click Continue Anyway.
5. Select Floppy only, and then click the Next button in the Driver Files Search Results
window.
6. Click the Finish button to complete the driver installation, and then repeat this
process for all the adapters on your system.