Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 12)

Page 12 LSI Corporation | January 2011
MegaRAID SAS Device Driver Installation User Guide Chapter 3: Novell NetWare Driver Installation | Installing the NetWare Driver in a New NetWare System
3.2 Installing the NetWare
Driver in a New NetWare System
Follow the instructions in the Novell NetWare Installation Guide to install Novell NetWare
in the server. Perform the following steps to install Novell NetWare using the MegaRAID
controller as a primary adapter:
1. Boot from Novell NetWare.
2. Follow the instructions on the screen until you reach the Device Driver screen,
which is used to modify drivers.
3. Select Modify, and press ENTER.
4. Select Storage Adapters on the Storage Driver Support screen, and press ENTER.
5. Delete any existing MegaRAID adapter listings.
6. Press INSERT to add unlisted drivers.
7. Press INSERT again.
A path displays.
8. Press F3.
9. Insert the driver diskette into the floppy drive, and press ENTER.
The system finds the .HAM driver.
10. Press TAB.
11. Select the Driver Summary screen, and press ENTER.
12. Continue the Novell NetWare installation procedure.
3.3 Installing or Updating the
NetWare Driver in an Existing
NetWare System
Perform the following steps to add the Novell NetWare driver to an existing installation:
1. Type the following command at the root prompt:
nwconfig
The Configuration Options screen displays.
2. Select Drive Options, and press ENTER.
A window displays.
3. Select Configure Disk and Storage Device Options, and press ENTER.
4. Select one of the following options displayed in the window:
— Discover and Load an Additional Driver
If you select Discover and Load an Additional Driver, the system discovers the
extra unit. The system prompts you to select a driver from the list. Press INSERT
to insert the driver. This completes the procedure.
— Select an Additional Driver
If you select Select an Additional Driver, the Select a Driver screen displays. Press
INSERT. Follow the instructions that appear.
Insert a floppy diskette into the floppy drive, and press ENTER.
The system finds the driver and installs it.