Sending document via e-mail, Configuring settings before sending, Sending scanned document via e-mail – Kyocera Taskalfa 3511i User Manual
Page 215: Sending document via e-mail -22, E-mail addr entry, Configuring settings before sending -22, Sending scanned document via e, Mail -22
5-22
Operation on the Machine > Sending Document via E-mail
Sending Document via E-mail
When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
Primary Network (Client) (page 8-62)
Configuring Settings before Sending
Before sending an E-mail, configure the SMTP and E-mail settings using the Command Center RX.
Sending Scanned Document via E-mail
1
[Home] key > [Send]
2
Place the originals.
3
In the basic screen for sending, select [E-mail Addr Entry].
4
Enter destination E-mail address > [OK]
Up to 128 characters can be entered.
To enter multiple destinations, select [Next Destination] and enter the next destination. Up to
100 E-mail addresses can be specified.
You can register the entered E-mail address in the Address Book by selecting [Add Address
Book]. You can also replace the information for a previously registered destination.
Destinations can be changed later.
5
Select the functions.
Press tabs to display other functions.
6
Press the [Start] key.
Sending starts.
Character Entry Method (page 11-9)
Confirmation Screen of Destinations (page 5-44)
NOTE
If [Prohibit] is set to “Broadcast”, multiple destinations cannot be entered.