TA Triumph-Adler LP 210 - Manual (Page 28)

2 Unpacking, installing and setting up the printer
2-12 Laser Printer 200 Series
Connecting the power cable
Only use the power cable supplied with the printer!
The laser printer requires a non-fluctuating power supply. If necessary,
ask an electrician for advice.
✔ Mains voltage: 220-240 V ± 10%
✔ Mains frequency: 50-60 Hz ± 0.3%
1 Make sure that the printer’s power
switch is in the "0" position (OFF).
2 Insert the plug on the end of the
power cable (supplied) into the
power socket of the printer.
3 Insert the other end of the power
cable into a power socket.
CAUTION
Using the wrong power cable may lead to a short-circuit!
The use of a power cable of inadequate cross-section can lead to a short-
circuit.
➜ Only use an extension cable which has a higher rating than the current
consumption of the printer.
➜ Only use earthed cables.
➜ Always observe the relevant local regulations regarding the
connection of electrical equipment to the mains network.
1
2