TA Triumph-Adler LP 210 - Manual (Page 102)

7 Working with the printer
7-6 Laser Printer 200 Series
Resetting the counter for the image transfer roller
After you have replaced the image transfer roller, reset the counter for the
image transfer roller.
1 Switch off the printer.
2 Hold down the control button and switch on the printer again.
The green “Stand-by“ lamp begins to flash.
3 Hold down the control button for another 5 seconds and then
release it.
All three lamps begin to flash.
4 Briefly press the control button again.
The amber “Fault“ lamp continues to flash. The other lamps go out.
After a few seconds, all three lamps begin to flash.
The counter for the image transfer roller has now been reset.
5 Switch the printer off and then on again.
Once the green “Stand-by“ lamp remains on permanently, the printer
is again in Stand-by mode.
✎
The counter can also be reset via the software!
The image transfer roller counter can also be reset via the “Counter“
function, see page 5-13.
Cancelling a print job
This cancels the print job currently being processed.
1 Hold down the control button for longer than 5 seconds.
2 Release the control button after all three lamps have gone out.
The current print job has now been cancelled.