Retrotec DucTester 200 Series Residential Applications - Manual (Page 45)

Page 45 of 91
©Retrotec Inc. 2015
7.1 Get the Excel spreadsheet based software to run on your system
7.1.1. Enable Macros (with Office 2007)
For the software to run properly, macros must be enabled. To enable macros:
Click the "Options…" button (by the Security Warning, on the toolbar shown below)
Select “Enable this content”
Click “OK”
Occasionally, you may get this popup prompt when you open Excel:
In this case, click “Enable Macros” and you will not have to perform the procedure above.
7.1.2. Enable Macros (with Office 2010)
For the software to run properly, macros must be enabled. Before Office 2010 allows you to enable
macros, depending on which version of the Duct Leakage Test Report software you have, there may be a
warning you have to bypass, before enabling macros. You may see the following “Protected View”
warning (red bar):
If so, click on it, and you will see the following Protected View option: