beautypg.com

Toolbag keeps all testing components in one place, Tubing accessory kit, Power cord – Retrotec DucTester 200 Series Residential Applications User Manual

Page 14: 9v power supply adapter for charging dm-2 gauge

background image

Page 14 of 91
©Retrotec Inc. 2015

1.4.4. Toolbag keeps all testing components in one place

The Deluxe Condura Toolbag provides enough volume to hold all the system components of a
DucTester System. It includes a shoulder strap for easy carrying. The vented exterior pocket is an
important feature, useful for storing your smoke puffer which will destroy your gauge and laptop
if stored together.

1.4.5. Tubing Accessory Kit

The Tubing Accessory Kit comes with blue, red, yellow and green pressure tubes (approximately
37 ft each, 1/8” inner diameter), four short male-to-male pressure tube connectors, two T-
connectors for pressure tubes, a Static Pressure Probe, and a copper wire. Attaching a Static
Pressure Probe to the pressure tube can prevent pressure reading interferences from wind or
other air flows blowing on the pressure tube. The copper wire can be inserted into a pressure

tube to prevent it from bending, and affecting the pressure reading.

1.4.6. Power Cord

The power cord is used to power your Model 200 fan. Once it is connected to a wall outlet, the
Mains Power status light turns green, indicating power is connected.

1.4.7. 9v Power Supply adapter for charging DM-2 gauge

The 9V Power Supply adapter is used to charge the DM-2 gauge’s batteries. For instructions on charging
the DM-2 batteries with the 9V Power Supply Adapter, refer to section 3.6.

Figure 11: A Tubing
Accessories Kit

Figure 12: A
power cord for
Model 200 fan

Figure 13: Power
supply adaptor for
the DM-2