Agility 3 user manual – RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf User Manual
Page 44

Agility 3 User Manual
Page 44
Event Message
Description
* Ksw full set:P=y
Partition Y is set by key switch
* Ksw unset:P=y
Partition Y is unset by key switch
L.bat rstr KF=yy
Low battery fault restore from wireless remote control YY
L.Temp rst Zn=xx
Low temperature alert restored from zone XX defined as a
temperature detector
* Lost Zone=xx
Wireless zone lost, zone no. XX
Low Bat rs Z=xx
Low battery fault restored from wireless zone no. XX
Low bat. Zn=xx
Low battery fault from wireless zone no. XX
Low bat.KF=yy
Low battery fault from wireless remote control XX
* Low Temp. Zn=xx
Low temperature alert from zone XX defined as a temperature
detector
Main:AC restore
AC power restore on main panel
Main: Battery rst
Low battery fault restore from the main panel
Main: Low AC
Loss of AC power from the main panel
Main: Low battery
Low battery fault from the main panel
* ARC=y call error
Communication fail fault to ARC phone no. Y
* ARC=y restore
Communication fail fault restore to ARC phone no. Y
* Msg Box Tamper
Tamper alarm from the Listen In message box unit
Msg Box Tmp Rst.
Tamper alarm restore from the Listen In message box unit
No Com IP card
Communication failure between the Agility and IP card
* No comm I/O Mdl.
Communication failure between the Agility and I/O module
* No comm Sounder=y
Communication failure between the Agility and sounder Y
* No comm. GSM
No communication between the GSM/GPRS Module and the Agility
* Phone fail
If the phone line is cut or the DC level is under 1V
Phone restore
Phone line fault restore
* Police Keypad=y
Police (panic) alarm from wireless keypad Y
* Police KF=yy
Police (panic) alarm from remote control YY
PTM: Send Data
Load new parameters into the Agility from PTM accessory
* Radio l.bat S=y
Radio low battery fault from sounder Y
Radio l.bat rS=y
Radio low battery restore from sounder Y
* Remote full set:P=y
The system has been set from the configuration software
* Remote program
The system has been programmed from the configuration software
* Remote part set:P=y
The system has been PART Set mode from the configuration
software
Restore Zone=xx
Alarm restore in zone no. XX
* RF Jamming
Wireless receiver jamming
Rmt unset:P=y
Partition Y unset from the configuration software
* Sounder=y Lost
Sounder Y is regarded as lost following supervision test
Sounder=y Lost Rst
The Agility received a signal from sounder Y after it has been
regarded as lost