Agility 3 user manual – RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf User Manual
Page 43

Agility 3 User Manual
Page 43
Event Message
Description
* GSM: Module comm.
Internal GSM/GPRS BUS module fault
* GSM:NET avail.
GSM network is not available
GSM:NET avail.OK
GSM Network is available
GSM:NET signl.OK
GSM Network quality is acceptable
GSM:NET signal
The GSM RSSI level is low
GSM:PIN code err
PIN code entered is incorrect
GSM:PIN code OK
PIN code is correct
GSM:PUK Code err
PUK code required
GSM:PUK Code OK
PUK Code entered is correct
GSM:SIM OK
SIM Card in place
GSM:SIM fault
SIM card missing or not properly sited
H.Temp rst Zn=xx
High temperature alert restored from zone XX defined as a
temperature detector
* High Temp. Zn=xx
High temperature alert from zone XX defined as a temperature
detector
HU Reinstate P =Y
Hold-Up Reinstatement in partition y
I/O:AC Rstr
AC power restore on I/O module
I/O:AC Fault
AC power fault on I/O module
I/O: Battery Rstr
I/O module battery fault restored
* I/O: Battery Flt
I/O module battery fault alert
* I/O: Jamming
I/O module jamming alert
I/O: Jamming Rstr
I/O module jamming alert restored
* I/O: Lost
I/O module is regarded as lost following supervision test
* I/O: Tamper
I/O module tamper alert
I/O: Tamper Rstr
I/O module tamper alert restored
IO: Lost Restore
The Agility received a signal from I/O module after it has been
regarded as lost
IPC:DHCP error
Failed to acquire an IP address from the DHCP server
IPC:DHCP ok
Succeeded to acquire an IP address from the DHCP server
* IPC: Network err
Failed to connect to IP network
IPC: Network ok
Successful connection to IP network
IPC:NTP error
Failed to acquire time data from the time server
IPC:NTP ok
Succeeded to acquire time data from the time server
Jamming OK Zn=xx
Zone XX jamming OK
Jamming restore
Wireless receiver jamming restore
* Jamming Z=xx
Zone XX jamming fault
KeyBox Open Z=!!
Zone XX defined as KeyBox type is open
KeyBox Rst Z=!!
Zone XX defined as KeyBox type is closed
KP=y Low Bat.Rst
Low battery fault restored from keypad Y
* KP=y Low Battery
Low battery fault from keypad Y