RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf - Manual (Page 41)

Agility 3 User Manual
Page 41
Appendix C - Engineer Event Log Messages
Event Message Description
Activate PO=xx PO XX activation
Actv PO=xx KF=zz PO XX is activated from remote control ZZ

AL Reinstate P=y Alarm reinstatement on partition Y
Alarm abort P=y Alarm aborted on partition Y
* Alarm Zone=xx Alarm in zone no. XX
* Anti-code reset Remote reset
Auto Add GSM GSM Module added to the main unit
Auto Add IP card IP Module added to the main unit
Auto Add MODEM Modem added to the main unit
Auto Del GSM GSM Module was removed from the main unit
Auto Del IP card IP Module removed from the main unit
Auto Del MODEM Modem removed from the main unit
Auto test fail Failure of zone self-test
Auto test OK Automatic zone self-test OK
* Set fail P=y Partition Y failed to set
* Set:P=y C=zz Partition Y armed by user no. ZZ
* Set:P=y KF=zz Partition Y armed by remote control ZZ
* Bell tamper Bell tamper alarm
Bell tamper rst Bell tamper alarm restore
* Box tamper Box tamper alarm from main unit
Box tamper rst Box tamper alarm restore
* Omit Box+Bell Box + Bell tamper is omitted
Omit code=xx Omit code XX has been used
* Omit Fault C=xx System faults were omitted by user XX
* Omit Zone=xx Zone no. XX is omitted
Cancel Alarm P=x Cancel alarm event has occurred from partition X. A valid user
function is entered to reset the alarm after the defined Abort alarm
time
Change code=xx Changing user code XX
Change FM=yy Changing Follow-Me number YY
Change tag=xx Changing keypad tag for user XX
Clock not set Time is not set
Clock set C=xx Time defined by user no. XX
Cloud Connected " , Cloud communication channel is functioning
Cloud Disconnect" , // Cloud communication channel is not functioning
CO Alarm Zn=xx CO alert from zone XX defined as a CO detector
CO Rst. Zn=xx CO alert restored from zone XX defined as a CO detector
Com ok IP card Communication OK between the Agility and IP card