RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf - Manual (Page 21)

Agility 3 User Manual
Page 21
Notes: If no voice is detected, the event message will start playing 5 seconds after phone
pick up. Press [#] to begin playback of the event message from the beginning.
To repeat the Event Announcement message press [#].
To omit the Event Announcement message and go directly to the Acknowledge
menu, press [
* ].
3. Acknowledge the event. (See Acknowledge Menu)
Acknowledge Menu
After the Event Announcement message is made, the following list of options is
announced:
Operation Digit
Acknowledge Message
Acknowledging an event means that you have received a message from
the security alarm system about a relevant event in the system and
want to confirm this. After you acknowledge an event, the system calls
the next FM number. Press [1]
Acknowledge and stop all dialing
This option acknowledges the event and stops the system from calling
the next FM numbers to report the event. Press [2]
followed by
the code
Acknowledge and access the Operations menu
The Operations menu lists the available options for remotely operating
your system. Press [3]
followed by
the code
Listen In and Talk
This option enables you to perform bi-directional communication. Press [6]
followed by
the code
Repeat the event message Press [#]
Repeat the Acknowledge menu Press [*]
Note: If an invalid code is entered 3 consecutive times, the system hangs up and this FM
number is locked for 15 minutes and no calls are initiated to the FM number.
If a valid user code is not entered within 10 seconds, the system hangs up.
Bi-directional Communication
The Listen In and Talk options enable you to remotely and silently listen in to your
premises in order to verify the cause of an event occurrence, through the microphone or
remotely talk to your premises via the Agility loudspeaker, for example, to guide someone
in distress.