Resetting after an alarm, Anti code reset, Engineer reset – RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf User Manual
Page 16: Agility 3 user manual

Agility 3 User Manual
Page 16
If an "Entry door" is opened prior to unsetting the system, the following voice
announcement message will be heard: "Alarm occurred in the system". Press the
key will indicate the cause of the alarm.
Note: If an alarm occurred in the system, it is recommended to leave the premises.
Only after police investigation should you consider that the intruder is no
longer on your premises and you can re-enter. In special cases (if programmed
by your engineer) setting the system after an alarm might require an engineer
code. For more information refer to your engineer.
Note: Your engineer can define the number of times (0-15) that an alarm will be sent
from the same detector during one setting period. This is usually used to
prevent an alarm from a malfunction detector, an environmental problem or
incorrect installation
Resetting after an alarm:
Your installation company can define that the reset of the system to a Normal Operation
mode will require the intervention of your alarm receiving centre or engineer. In this
case, after an alarm condition the system will be regarded as Not Ready and while
requesting for system status (
) indication you will get a fault message: Engineer
Reset.
Anti Code Reset
Press
.
Enter user code
Go to Activities > Anti Code option.
Call your alarm receiving centre (ARC) or engineer and quote the
“RANDOM CODE” displayed on your keypad. The ARC or engineer will
give you a return Anti-Code.
Enter this Anti code followed by
and the system will reset.
Engineer Reset
Your alarm receiving centre (ARC) or engineer can reset your system remotely or
locally from the keypad.