Status led/buzzer indications, Changing remote control pin code, Code – RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf User Manual
Page 40: Agility 3 user manual

Agility 3 User Manual
Page 40
Code
Status LED/Buzzer Indications
After each transmission (indicated by a flashing Green LED) from the remote control, the
Agility sends a status response indicated by the remote control's LEDs and Buzzer:
LED Indications
Operation
1st LED *
(Send
command)
2nd LED
(Receive
Status)
Full Set
Green
Red
Part Set
Green
Orange
Unset
Green
Green
Alarm
Green
Flash Red LED
*If the 1st LED changes to orange it indicates a low battery condition.
Buzzer Indications
Sound
Status
1 beep
Confirmation
3 beeps
Error
5 beeps
Alarm
Changing Remote Control PIN Code
Each remote control can be defined by your engineer to be activated with a unique PIN
code.
To change the remote control PIN code (from the remote control itself):
Note: To change the PIN code it is mandatory to perform the following procedure in close
proximity to the control panel.
Press the
+
4\?
simultaneously for 2 seconds.
Enter the remote control current 4 digit PIN code.
Press
followed by a new 4 digit code.
Press
.
The panel will send a confirmation message. The remote control will sound a long beep
and the Green LED will turn on. If no confirmation sound is heard the old PIN code will
remain. Repeat the procedure again to replace to a new code.