MCZ Vivo 80 Pellet HYDRO - Manual (Page 49)

Esc Set
< Impostazione >
21.0°C 21.04
OFF
Mode:AUTO Menu
Temp:22°C Fan:A
Esc Set
< Impostazione >
Esc Set
< Lingua >
Esc ON OK
< Lingua >
47
7 - CONTROL PANEL
Technical Dept. - All rights reserved - Reproduction is prohibited
SETTING THE LANGUAGE
Press the MENU key then scroll with the keys at the bottom on the right or left until SETTINGS appears, press SET and LANGUAGE will
appear, press SET again and set the chosen language.
By convention the days of the week are indicated with abbreviations deriving from the language set on the panel. In the case of English:
MO Monday TH Thursday SU Sunday
TU Tuesday FR Friday
WE Wednesday SA Saturday
21.0°C 21.04
OFF
Esc Set
< Setting >
Esc Set
< Setting >
Esc Set
< Language >
Esc Set
< Language >
Mode: AUTO Menu
Temp: 22°C Fan: A
RECIPE SELECTION PROCEDURE
On the control panel menu, "Recipe" appears under the settings menu. This function is for increasing or decreasing pellets loading into
the hopper and is represented as follows:
• To increase: +1 +2 +3 that corresponds to 10-20-30% more compared to the standard recipe set by the company.
• To decrease: -1 -2 -3 that corresponds to 10-20-30% less compared to the standard recipe set by the company.
CHIMNEY SWEEP FUNCTION
ATTENTION.
The "Chimney sweep" function is a technical function aimed at a specialised technician for product calibration
(where required by law) therefore the user must absolutely not activate it.
To activate the Chimney Sweep function one must enter in MENU-SETTINGS-CHIMNEY SWEEP (after the °C-°F entry).
Once the function has been activated the stove will work at maximum power (loading, smoke ventilation, room ventilation) without
listening to any modulation/shutdown requests of the external (thermostat, eco-stop, modem, home automation control) and internal
probes. The only limit that must stay active is the safety threshold of 85°C in the boiler, and relative electronic shutdown in the event of
exceeding this parameter.
The test will work until the technician decides to disable the function by pressing esc or the on/off button.
SETTING WATER TEMPERATURE IN BOILER
The stove has already got a series of standard parameter settings which allow it to operate properly (water temperature 65°C). The water
temperature is shown on the control panel display.
If the user wishes to change the parameters relating to the temperature he/she can do so as follows:
T H2O = Maximum temperature of water in boiler. Upon reaching this temperature, the stove will reduce its performance to prevent
overheating.