MCZ Vivo 80 Pellet HYDRO - Manual (Page 26)

24
4-INSTALLATION AND ASSEMBLY
HOOD VENTILATION GRILLES
Foreword
Depending on how the product is positioned, one must provide grilles for ventilation.
If inserted in existing cladding, the ventilation grilles on the cladding will be used.
If used as a new installation, the company recommends installing the ventilation grilles as described in the following paragraph.
HOOD VENTILATION GRILLES FOR NEW CLADDING
It is mandatory to install the hood ventilation grilles of the manufacturer or grilles that can guarantee the same functions
and the same air passage section.
The company cannot be held liable for any damage caused to the structure or the electrical components if this precaution
is not complied with.
The structure becomes very hot and it is essential that constant and efficient ventilation is always guaranteed inside the cladding.
This allows to recover part of the structure heat that would otherwise be lost if left inside the cladding, whilst guaranteeing perfect
product operation.
The company supplies the “Blade” nozzle that is to be installed in the upper part of the insert as shown in the figure.
CONVECTION HOT AIR: ONE MUST RELEASE THE
HOT AIR ACCUMULATED INSIDE THE CLADDING.
AIR INFLOW FROM THE ROOM: ALLOWS AIR
RECYCLE. ONE MUST PROVIDE AN OPENING IN
THE LOWER PART OF THE CLADDING TO PROMOTE
CONVECTION.
SUPPLIED “BLADE” GRILLE
CONVECTION HOT AIR
HOT AIR INFLOW FROM THE ROOM