Installation and assembly, Diagram for making holes in the cladding – MCZ Vivo 80 Pellet HYDRO User Manual
Page 29
27
4-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
DIAGRAM FOR MAKING HOLES IN THE CLADDING
PELLET LOADING DOOR INSERTION HOLE
The product can be installed on a brick base built on site or one can purchase the support (optional) that enables to raise the product to
a suitable height. The recommended measurements go from 50 to 60 cm below the product support surface.
To make the hole for inserting the loading door there are standard measures required by the same length of the loading pipe.
Below is the drawing with the recommended and required measurements in order to ease fast installation.