MCZ Ego AIR - Manual (Page 49)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 49
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
 BREAKDOWN OF THE REDUCTION MOTOR
If the reduction motor stops, the stove continues to function until it
has cooled down to the minimum level.
 TEMPORARY POWER CUT
If there is a power outage during operation, when the power
comes back on the stove will go into cooling mode and then it will
come back on automatically.
 FAILURE TO LIGHT
If during ignition no flame develops, the stove will go into alarm
condition.
TAMPERING WITH THE SAFETY DEVICES IS
PROHIBITED
It is only after eliminating the cause which gave rise to the
intervention of the safety system, that it is possible to relight
the stove and thus reset the automatic operation of the
sensor. To understand which anomaly has occurred, consult
this manual at paragraph 4.14 which explains what to do
based on the alarm message the stove displays.
ATTENTION
If the stove is not used as described in this instruction booklet,
the manufacturer refuses to accept any responsibility for
damage to persons and property that may arise. The
manufacturer furthermore refuses to accept responsibility for
damage to persons and property arising from the failure to
observe all the rules contained in the manual and in particular:
 Failure when carrying out works of maintenance, cleaning
and repair to adopt all necessary measures and
precautions
 Tampering with the safety devices.
 Removing the safety devices.
 Failure to connect the stove to an efficient system for the
discharge of smoke.
 Failure to check in advance that the room where the stove
is to be installed is adequately ventilated.
4.14.
ALARM SIGNALLING
Should an operation problem occur, the stove enters a shutdown phase
for alarm and informs the user of the type of fault that occurred using a
3 digit code that remains displayed on the control panel of the stove
(and a short description of the alarm type)
The table below describes the possible alarms signalled by the stove,
associated to the respective code that appears on the emergency panel,
and useful suggestions to solve the problem.