MCZ Ego AIR - Manual (Page 41)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 41
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
4.8.1. COMFORT AIR version
In this version, the stoves are equipped with two fans which duct the
hot air at the front and rear. Conventionally, we will refer to “fan 1” as
the one releasing air at the front and to “fan 2” as the one with the
rear outlet. The adjustment of the two fans summarised in the table
below is independent and is set on the control panel.
Type Fan speed
Fan 1 0 1 2 3 4 5
Fan 2 0 1 2 3 4 5
35 POSSIBLE COMBINATIONS
COMBINATION 0-0 IS NOT PERMITTED
The procedure is similar to the AIR version. Press the bottom right key
(fig. 1), in the second screenshot the bottom left key, corresponding to
the word “Fire” to modify the flame power. Use the bottom right key to
display the last setting entered for the two fans (fig. 3), or hold down
this key (fig. 3) for a few seconds to modify the speed of fan 1 or 2. To
change the speed of the fans (always beginning with Fan 1), press the
key relating to + or – (fig. 4), then confirm by pressing OK (fig. 5) and
move on to the next fan.
The air at the rear (fan “2”) can be released naturally from the outlet E
fitted as standard (see chapter 3.4) or it can be ducted through outlets
or pipes which are available for purchase as accessories (see chapter
3.4).
26° 10.30
ON Mode:MANU Menu
Fire:3 Fan1:4
Esc OK
- Fan1 + Mode:MANU Menu
Fire:3 Fan1:4
Esc OK
- Fan1 +
If the control panel keyboard is left unused for 10
seconds, it automatically quits fan adjustment mode
and confirms the last setting made.
If low fan settings are made, the power of the stove
will be automatically limited to avoid the structure
and the air released by the room fans from
overheating.