MCZ Ego AIR - Manual (Page 30)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 30
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
4.4.2.1. General characteristics of the LCD remote
control
The EGO and STAR stoves are mainly controlled by the control panel
that is found above the stove. As an accessory, it is in any case possible
to purchase the remote control that manages the main functions:
on/off, power adjustment, hot air fan speed adjustment, automatic
function.
Keep the remote control away from direct heat and
water.
It is advisable to keep it out of the reach of children.
4.4.2.2. Type of batteries and replacement
To substitute the battery, it is necessary to extract the battery-holder
(as shown on the figure on the back of the remote control), and remove
or insert the batteries following the symbols printed on the remote
control and the battery itself.
Operation requires 1 CR 2025 Lithium battery.
If the remote control is off due to the absence of
batteries, it is possible to control the stove from the
control panel, located in the upper part of the stove.
When replacing the batteries, ensure correct polarity
by observing the symbols on the internal
compartment of the remote control.
4.5.
SETTINGS TO CARRY OUT BEFORE FIRST
LIGHTING
Once the power cord is connected to the rear part of the stove, place
the switch, also on the rear, to position (I).
The lighted button of the switch will come on.
The switch located to the rear of the stove powers the system.
The stove is off and on the panel the first screen appears with the word
OFF; by pressing any key the screen with the word MENU will appear.
Used batteries contain metals which are harmful for the
environment; they must therefore be disposed of
separately in the special containers.