MCZ Ego AIR - Manual (Page 20)

PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL page 20
Installation and fitting Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
H
G
I
C
E
D
3.3.
LATERAL CLADDING ASSEMBLY
THE 6 CERAMICS AND THE 4 SIDES MADE OF
SOAPSTONE THAT ARE LATERAL TO THE STAR STOVE
ARE ALL THE SAME.
Assembly of profiles to insert steel sides (for EGO stove only)
Remove, on the upper part, the cast iron top (A).
Take the two profiles (B) to be assembled on the front part of the stove
(one to the right and one to the left). Make sure that the profile (B) at
the bottom enters the hole predisposed on the base for securing
purposes, and along the side enters the blade (B1) predisposed in the
stove along its entire height. Once this operation is performed, take the
piece (C) with the two screws (D and E) and secure the profile on the
top part of the stove. The screw (D) must be secured on the upper
sheet metal of the stove, while the screw (E) must be secured on the
area predisposed on the profile (B2).
Take the side (I) and secure it to the upper sheet metal of the stove
with the two screws (G and H) provided.
In the front part it must be inserted in the housing (B3) of the profile
(B).
Repeat the same operation for both sides. Reposition the cast iron top.
Figure 5 - EGO stove steel sides