MCZ Ego AIR - Manual (Page 37)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 37
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
B
C
4.7.3.2. External
environment thermostat
connection
It is possible to connect the stove to an external thermostat. To make
this connection it is necessary to acquire the interface D (optional) that
is connected to the motherboard (E) of the stove on the manifold (F) as
indicated in the diagram below and in pag.53 par.7.
E
D
F
A
B
On the terminal indicated by the arrow, on the housings (A) and (B)
indifferently insert the two wires of the room thermostat. These wires
must pass through the hole G predisposed on the back of the stove.
Thermostat and related electrical cables are on the user's account.
Installation must be performed by a specialised MCZ technician.
On the control panel of the stove, once the thermostat is connected,
the temperature detected by the probe will continue to appear;
however, in this case the temperature set on the thermostat will be
valid.
The activation of the thermostat (on/off) on the control panel is possible
from the menu, settings, on/off option thermostat, as explained in the
diagram below.
Fig.9 - Interface for the
environment thermostat
A = PROTECTION CAP
B = PROBE (FLUSH)
C = CLAMP
D
= INTERFACE FOR
EXTERNAL THERMOSTAT
E = MOTHERBOARD
F
= CONNECTOR FOR
INTERFACE CONNECTION
G = HOLES FOR CABLE
OUTLET
Fig. 8 - Motherboard (internal
stove)