MCZ Ego AIR - Manual (Page 22)

PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL page 22
Installation and fitting Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
E
F
PARETE DI
ATTRAVERSAMENTO
ISOLANTE
STUFA
TUBO USCITA
ARIA CALDA
3.4.
HOT AIR DUCTING CONNECTION ON EGO
AND STAR COMFORT AIR MODELS
Once the stove has been positioned correctly, you may start installing
the hot air piping.
COMFORT AIR stoves are supplied as standard with an air diverter E, in
other words the rear hot air outlet flange is connected to this deviator,
which makes it possible to direct the hot air towards the left or right
side of the room, in case you do not wish to duct the hot air.
If you wish to duct the hot air, you will need to remove the diverter E,
connect the soundproofed union F (optional) which transforms the
square outlet into a round one and then make the various connections
with purpose-designed MCZ pipes and unions that divert the flow into
several hot air diffusers (120x120 mm hot air outlet). Such ducting may
also be walled. (SEE OPTIONALS)
The air outlet pipe may reach very high temperatures,
nearing 200 °C: it is therefore necessary to insulate it
appropriately and with suitable materials, wherever
it may come into contact with flammable or heat-
sensitive (e.g. fading of colours, electrical wireways,
plasterboard, etc.); it is also necessary to protect
persons and animals from voluntary or accidental
contact. In any case, always observe the applicable
regulations and laws in the region where the
appliance has been installed.
It is advisable to provide for insulation along the
entire route of the pipe to minimise dispersion and
increase heat output to the room.
STOVE
HOT AIR
OUTLET PIPE
THROUGH WALL
INSULATOR