Epson AcuLaser C9300 - Manual (Page 94)

The current time setting is reset because you did not connect the power cord for a long time. To clear
this error, select Time Setting from Clock Menu and specify the current date and time.
Dev Unit uuuu Needed Soon
This message indicates that the development unit is near the end of its service life. You can continue to
print until the Replace Dev Unit uuuu message appears.
To clear this warning message and continue printing, select Clear All Warnings from the control
panel’s Reset Menu. For instruction about accessing the control panel menus, see “How to access the
control panel menus” on page 60.
DM Error yyy
An inappropriate Duplex Unit is installed. Remove the Duplex Unit.
Duplex Memory Overflow
There is not enough memory for duplex printing. The printer prints only on the front and ejects the
paper. To clear this error, follow the instructions below.
If Off is selected as the Auto Cont setting on the control panel’s Setup Menu, press the Start/Stop
button to print on the back of the next sheet, or press the W Pause/Cancel button to cancel the print
job.
If On is selected as the Auto Cont setting on the control panel’s Setup Menu, printing continues
automatically after a certain period of time.
Feed Roller MP Needed Soon, Feed Roller C1 Needed Soon, Feed Roller C2 Needed Soon,
Feed Roller C3 Needed Soon, Feed Roller C4 Needed Soon
This message indicates that the feed roller C2, C3, or C4 is near the end of its service life. You can
continue to print until the Replace Feed Roller MP, Replace Feed Roller C1, Replace Feed
Roller C2
, Replace Feed Roller C3, or Replace Feed Roller C4 message appears.
To clear this warning message and continue printing, select Clear All Warnings from the control
panel’s Reset Menu. For instruction about accessing the control panel menus, see “How to access the
control panel menus” on page 60.
Form Data Canceled
Epson AcuLaser C9300 Series User's Guide
Using the Control Panel 94