Epson AcuLaser C9300 - Manual (Page 89)

Specifies the length of the time until the printer enters the preheat mode when the Preheat Mode is
set to On. The printer does not enter the preheat mode if the specified time in Time to Preheat is the
same as or longer than that of Time to Sleep.
Time to Sleep
Specifies the length of the time until the printer enters the sleep mode or deep sleep mode if there are
no button operations and no jobs to be printed.
Deep Sleep Mode
When this setting is set to On, the printer switches into the deep sleep mode at the time specified in the
Time to Sleep
setting if the printer is not operated or receives no jobs. In the deep sleep mode, the
Wake Up/Sleep button lights and more power is saved than when in the sleep mode. The printer
switches to the deep sleep mode only when the AppleTalk, WSD, IPv6, and IPSec settings in
Network Menu
and RAM Disk in Setup Menu are set to Off.
To recover from the deep sleep mode, press the Wake Up/Sleep button. The printer recovers
automatically when it receives a print job.
Power Off Timer (Power Off mode)
When this setting is set to On, the printer switches into the power off mode at the time specified in the
Time to Off
setting. The printer does not enter the power off mode if it is receiving or sending data.
The power off mode consumes about 0.2 W by disabling almost all operations. In the power off mode,
the Wake Up/Sleep button blinks.
The printer recovers from the power off mode at the time specified in the Start setting, or if you
pressed the Wake Up/Sleep button.
Time to Off
Specifies the length of the time until the printer enters the power off mode if there are no button
operations and no jobs to be printed.
Timer Setting
When this setting is set to On, the printer enters or recovers from the power off mode at specified
times.
Start
Specifies the time when the printer recovers from the power off mode.
Epson AcuLaser C9300 Series User's Guide
Using the Control Panel 89