Powerfix Z31712A/Z31712B Z31712C/Z31712D - Manual (Page 45)

45 GB/MT
Remove the screws 2 from the front of the motion detector (see Ill. B).
Insert the cable through the cable opening of the base plate 4 .
Screw the base plate 4 to the desired position.
Connect the cable to the screw terminal 3 of the motion detector as
depicted in Ill. C.
Attach the cover of the connection area back to the base plate 4 by
screwing the screws 2 .
Start-up
Turn the electricity back on. The device is now ready for use.
Setting the sensitivity of the sensor (Ill. D)
Only models Z31712C/D
Note: the sensor range is max. 12 m (depending on the surrounding
temperature).
Turn the control knob SENS 8 in the direction „-” in order to reduce
the sensor range 1 .
Turn the control knob SENS 8 in the direction „+” in order to
increase the sensor range 1 .