Epson GT-6500 EN - Manual (Page 185)

Software Functions and Settings
The function level of the GT-1000 is B2. The table below lists the
functions and settings that can be controlled with software
commands.
Function Available settings
Output resolution 3 settings (50, 100, 200 dpi)
Zoom 50% to 200% in 10% increments
Reading area 592
×
840 dots at 200 dpi, 100%
Data format 1 to 8 bits per pixel per color
Color mode color (page sequence),
monochrome (standard and with dropout color)
Brightness 7 levels
Halftoning mode 3 modes
Gamma correction 5 settings
Software Defaults
With the DIP switches at the preset factory settings, the following
values are the default values on the GT-1000 when the power is
turned on.
Function Command Default value
Data format ESC D i=01
H
(1 bit/pixel/color)
Resolution ESC R n1=100, n2=100 (dpi)
Zoom ESC H i1=100, i2=100 (%)
Reading area ESC A n1=0, n2=0, n3=296, n4=420 (dot)
Color mode ESC C i=00
H
(monochrome)
Brightness ESC L BRIGHTNESS dial setting
Gamma correction ESC Z i=01
H
(CRT Display A)
Halftoning mode ESC B i=00
H
(Halftoning Mode A)
Scanner Model Technical Data B-3