Sealey VS8622 - Manual (Page 25)

20) Press Y button to continue.
21) Wait a few seconds until following screen shows:
.... 5 .. Change Fluid .... .
Operate the brake pedal
at least 5 times
and release again
(pump).
The number “x” on the upper left corner of screen indicates
how many times you need to operate the brake pedal.
22) Operate the brake pedal at least 5 times as instructed.
23) Follow onscreen instructions to finish the eighth phase.
- Hold bleeder hose tight.
24) Press Y button to continue.
25) Follow onscreen instructions to finish the ninth phase.
- Close bleeder screw at front left brake calliper.
- Open bleeder screw at front right brake calliper.
- Operate brake pedal at least 5 times and release again (pump).
- Stop pumping once the brake fluid flows out free of bubbles.
- Hold bleeder hose tight.
26) Press Y button to continue.
27) Wait a few seconds until following screen shows:
.... 5 .. Change Fluid .... .
Operate the brake pedal
at least 5 times
and release again
(pump).
28) Operate the brake pedal at least 5 times as instructed.
29) Follow onscreen instructions to finish the tenth phase.
- Hold bleeder hose tight.
30) Press Y button to continue.
31) Follow onscreen instructions to finish the eleventh phase.
- Close bleeder screw at front right brake calliper.
- All bleeder screws are closed.
VS8622_1.03_12/03/09
24