Sealey VS0205 - Manual

 Keep this product in good working order and condition, take immediate action to repair or replace damaged parts.
 Use approved parts only. Unapproved parts may be dangerous and will invalidate the warranty.
 Keep children and unauthorised persons away from the work area.
 Keep work area clean and tidy and free from unrelated materials.
 Ensure the work area has adequate lighting.
 DO NOT use the kit to perform a task for which it is not designed.
 DO NOT allow untrained persons to use the kit.
 DO NOT use when tired or under the influence of drugs, alcohol or intoxicating medication.
 After use, clean equipment and store in a cool, dry, childproof area.
 Dispose of waste liquids in accordance with local authority regulations.
 Always read and comply with the warnings on the brake fluid container.
 Wear eye protection and keep skin contact to a minimum. If brake fluid enters eyes rinse with plenty of water and seek medical advice.
If swallowed seek medical advice immediately.

WARNING! Only use new Brake Fluid, used Brake Fluid or other fluids will contaminate the system and possible brake system failure may
result.

WARNING! DO NOT pollute the environment by allowing uncontrolled discharge of fluids.
 WARNING! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.
 WARNING! Brake fluid will damage paintwork. Any spillage should be flushed with water immediately.
1. SAFETY INSTRUCTIONS
INSTRUCTIONS FOR:
AUTOMATIC BRAKE & CLUTCH
BLEEDER
MODEL NO:
VS0205
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Fast, easy and effective bleeding of brakes and clutch using air from tyre. Innovative design incorporates valve for control of air pressure,
extra-long air hose for use with larger vehicles and magnetic reservoir base to prevent accidental spillage. Suitable for use with ABS systems.
Supplied with range of common adaptors.
Model No: VS0205
Maximum Air Supply: 20 psi
Accessories
1 x 25mm Cap and Seal for Lockheed Systems.
1 x 27mm Cap and Seal for VAG.
1 x 44/45mm Cap with 2 Seals
(1 x thin for 44mm Cap and 1 x thick for 45mm Cap) for metal Girling and ATE Systems
1 x 46mm Cap and Seal for some Girling Systems
2 x Bleed Pipes
2. INTRODUCTION
Original Language Version © Jack Sealey Limited VS0205 Issue: 2(L) - 02/12/13