Eicon Networks Diva 2440 - Manual (Page 74)

Command Line Reference Page 74
IP Commands (General)
SET IP ADDRESS
Valid context: Profile, Port
Sets the IP address this profile should use if a static address is assigned to the device by your
ISP or network administrator. In most cases, specify 0.0.0.0 to allow dynamic negotiation when
the connection is established.
Note: Dynamic negotiation is not supported by the LAN profile.
SET IP MASK
Valid context: Profile, Port
Sets the subnet mask for this profile.
SHOW IP ADDRESS
Valid context: GENERAL PROFILE PORT
Displays the current IP address. The addresses you see may be the ones negotiated by IP and
not the ones you have defined. For example, if an IP address is set to 0, it is negotiated to a
new value when the device connects. Addresses for the current profile are displayed unless
you are in the GENERAL context, in which case all addresses are displayed.
SHOW IP CONFIGURATION
SHOW IP STATUS
Valid context: Profile, Port
Displays IP configuration settings for the current profile or context.
ENABLE IP DIALONDEMAND
DISABLE IP DIALONDEMAND
Enables/disables IP dial-on-demand. When this feature is enabled, the actual connection will
be established only when the Diva 2440 receives an external access request. When
dial-on-demand feature is disabled, the unit is set to always-on mode.
SET IP DEFAULT GATEWAY
Sets the IP address of a default remote gateway. The command will modify/add a default IP
route pointing to the gateway specified in the argument.
Note: Setting the default gateway address is only necessary for IPoE profile type and only when
a static configuration is used (DHCP client is disabled).
SET IP DNS1
SET IP DNS2
Defines the DNS address (DNS1 for primary; DNS2 for secondardy) to be used by the internal
DNS relay.