Eicon Networks Diva 2440 - Manual (Page 64)

Command Line Reference Page 64
DHCP Commands
SET DHCP TYPE
Sets the type of DHCP services provided to other network devices. The DHCP server is
enabled by default.
SHOW DHCP STATUS
Displays DHCP server status and a list of currently-defined IP addresses.
SET DHCP IPRANGE
Defines the pool of addresses used to assign dynamic addresses when operating as a DHCP
server.
Example: If the starting address is set to 192.168.1.2 and the range is set to 10, addresses
192.168.1.2 to 192.168.1.11 are available for DHCP.
SET DHCP LEASEDURATION
Defines the length of time a client address assigned by the DHCP server is valid.
SET DHCP DNS
Defines the primary and secondary DNS server addresses sent to a DHCP client when a
DHCP lease is requested. By default, the primary DNS is 192.168.1.1 (this is the default
address of the device); the secondary is blank.
SERVER IP addresses will be dynamically assigned when a DHCP request is
received from a network device.
RELAY Relays DHCP requests to a separate DHCP server (use SET DHCP
SERVERADDR to specify).
NONE DHCP requests are ignored.
Starting address for the pool. This address must be on the same
network as the LAN IP address. Default: 192.168.1.2.
Number of addresses in the pool. Range: 1-250. Default: 250.
Range 30 minutes to 30 days.
Primary DNS server.
Secondary DNS server.
IP address of the DNS server.