Eagle Electronics Cuda 240 S/GPS - Manual (Page 90)

84
Sequence for setting a waypoint. Step 1: while traveling, quickly press
WPT twice to call up Find Waypoint screen (shown at left) and set a
point. Step 2: a message says the waypoint has been saved (shown cen-
ter). Step 3: vehicle continues on its way; number waypoint symbol is
visible on plotter (shown at right).
NOTE:
The Quick Save method uses the default waypoint symbol until you
edit an existing waypoint and change its symbol. After you have
changed a waypoint symbol, the unit will remember the one you
chose and use it the next time you "quick save" a waypoint. To re-
vert back to the default symbol, edit a waypoint and choose it, or
use the Reset Options command (described in Sec. 7).
Create Waypoint on Plotter
1. Use the arrow keys to move the cursor to the place where you want
to make a waypoint.
2. Press WPT | WPT . The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the plotter.
Create Waypoint by Entering a Position
1. Press WPT |
↓ to
C REATE N EW
| ENT .
2. Press
↓ to
E NTERED P OSITION
| ENT | ENT .
3. Press
↓ to
L ATITUDE
| ENT . Enter the latitude by pressing
↑ or ↓ to
change the first character, then press
→ to the next character and re-
peat until the latitude is correct. Press ENT .
4. Press
↓ to
L
ONGITUDE
| ENT . Enter the longitude by pressing
↑ or ↓ to
change the first character, then press
→ to the next character and repeat
until the longitude is correct. Press ENT , then EXIT | EXIT to return to the