Eagle Electronics Cuda 240 S/GPS - Manual (Page 67)

61
Digital Data/Chart
Sonar Simulator
This unit has a built-in simulator that lets you run it as if you were on
the water. All sonar features and functions are useable. When in
simulator mode, you will see [Simulator Mode] in the Sonar Page title
bar. To use the simulator:
1. From the Sonar Page, press MENU | MENU |
↓ to
S ONAR S IMULATOR
| ENT .
2. Turn off Sonar Simulator by pressing MENU | MENU |
↓ to
S
ONAR
S IMULATOR
| ENT | EXIT .
NOTE:
If you turn on your unit before attaching a transducer, it may enter a
demo mode. The words "demo mode" in a pop-up box flash in the
middle of the screen and a sonar chart plays much like the simulator.
Unlike the simulator, the demo mode is for demonstration only, and
will automatically stop as soon as you turn on the unit with a trans-
ducer attached. The simulator will continue to function normally.
Stop Chart
If you are running multiple units on a boat, there are times when you
may want to turn off the sonar. This command turns off the sonar and
stops the chart from scrolling. Sonar restarts automatically each time
you turn on your unit.
Press MENU |
↓ to
S
TOP
C
HART
| ENT | EXIT .
To turn on sonar and start the chart scrolling again, repeat the above step.