Eagle Electronics Cuda 240 S/GPS User Manual

Page 29

lead, black is negative or ground. Make sure to attach the in-line fuse
holder to the red lead as close to the power source as possible.

For example, if you have to extend the power cable to the battery or
power buss, attach one end of the fuse holder directly to the battery or
power buss. This will protect both the unit and the power cable in the
event of a short. It uses a 3-amp fuse.

WARNING:

This product must be independently fused with the en-
closed 3-amp fuse (or equivalent), even if you connect to
a fused accessory or power buss.

If a malfunction happens inside the unit, extensive dam-
age can occur if the enclosed fuse is not used. As with all
electrical devices, this unit could be damaged to a point
that it is unrepairable and could even cause harm to the
user when not properly fused.

CAUTION:

Failure to use the enclosed 3-amp fuse will void your warranty! For
a replacement, use a type 3AG 3-amp fuse.

This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.

MOUNTING THE SONAR UNIT: In-Dash or Bracket

You can install the sonar unit on the top of a dash with the supplied
bracket. It can also be installed in the dash with an optional FM-6
dash-mounting kit.

In-Dash Installation

The following figure shows the approximate shape for in-dash mounting
an Cuda 240. The in-dash adapter kit includes a template for cutting the
mounting hole and complete installation instructions on instruction
sheet 988-0147-631.