Eagle Electronics Cuda 240 S/GPS - Manual (Page 107)

101
Route creation sequence: At left, the Plotter Page shows the waypoints
we want to visit in our route. Set the first route point at waypoint
(001). Center, move cursor to the next waypoint in the route and press
Enter. Waypoint added message appears. Right, continue adding way-
points until you reach the end of the route.
5. Move the cursor to the next point in the route (waypoint 2 in our ex-
ample; this could also be a spot where you need to turn or change direc-
tion), and press
ENT to set the next waypoint.
6. Repeat step five until the route reaches your destination.
7. To save your route, press EXIT . The Cuda 240 reverts to the Edit
Route screen, with the route automatically named "Route 1" and stored
in the Cuda 240's internal memory.
You can edit the route and run other commands, but if you are finished
with the route for now, r e t u r n t o t h e l a s t p a g e d i s p l a y e d b y
p r e s s i n g
EXIT | EXIT | EXIT | EXIT | EXIT .
Delete a Route
1. From the
N AVIGATION P AGE
, press MENU | ENT or from the P LOTTER P AGE
press MENU | MENU |
↓ to
R OUTE P LANNING
| ENT .
2. Press
↓ to route name|
ENT .
3. Press
↓ to
N AVIGATE
| ENT |
→ to
D ELETE
| ENT |
← to
Y ES
| ENT .
Tip:
You can also delete all routes at once:
1. From the
N
AVIGATION
P
AGE
, press MENU | ENT or from the P
LOTTER
P
AGE
press MENU | MENU |
↓ to
R
OUTE
P
LANNING
| ENT .
2. Press
→
to D
ELETE
A
LL
| ENT |
← to
Y
ES
| ENT .