Eagle Electronics Cuda 250i - Manual (Page 163)

155
Delete All Trails
To remove all of the trails from memory: from the Trails Menu, press
→
to D
ELETE
A
LL
| ENT |
← to
Y
ES
| ENT .
To Update Active Trail
From the Trails Menu, press
→ to
T RAIL O PTIONS
| ENT . With U PDATE T RAIL
highlighted, press ENT to turn it on (check) or turn it off (uncheck).
WARNING:
If you uncheck the Update Trail option, automatic trail
creation and recording will be turned off. You must turn
it back on to record trails. The default setting is on.
Update Trail Criteria
There are three options for updating trails: automatic, time or distance.
When it is in default mode (automatic), the unit does not update the
plot trail while you are traveling in a straight line. Once you deviate
from a straight line, the unit drops a plot point onto the trail. This con-
serves plot trail points. If a plot trail uses all of the available points al-
lotted to it, the beginning points are taken away and placed at the end of
the trail.
From the Trails Menu, press
→ to
T RAIL O PTIONS
| ENT |
↓ to
U PDATE
C RITERIA
| ENT . Use
↑ ↓
to select criteria type| ENT . If you selected Time,
the Update Rate data entry box appears on the menu. If you selected
Distance, the Update Distance data entry box will appear.
Trail Update Rate (Time, Distance)
You can update a trail by time with a range of 1 to 9999 seconds. The
default is 3 seconds. There is a range of 0.01 mile/nm/km to 9.99
mile/nm/km if you update by distance. The default is 0.10 miles.
With one of the Update Criteria — Time or Distance — selected, high-
light the update criteria data entry box and press
ENT .