Epson 1440 User Manual

Page 87

Section 10 : Updating the Software

AXIS 1440 User’s Manual

Follow these steps to upgrade the AXIS 1440:

Caution!

❏ Be sure not to interrupt the file transfer. If you do, your AXIS

1440 may not be able to initialize. Contact

EPSON

or an

EPSON

Authorized Service Center if this occurs.

1. Use the command

ftp

to log

into the AXIS

1440, where <

host name>

is the host name assigned to your

AXIS 1440.

2. When prompted, enter the user id

root

, and the default password

pass

3. Enter the command

binary

to change to binary transfer mode.

4. Enter the command

put flash

, where

is the name of the new print server software,

(for example,

1440_551.bin

5. Wait for the flash loading operation to finish. (This normally

takes 1 to 4 minutes.) The unit automatically restarts with the
new print server software.

6. Log out using the command

quit,

bye

exit,

depending on

your FTP version.

Note:

❏ If you have problems upgrading over the network, contact your

dealer or

EPSON

for more information.